Porsche Boxster leaky window seal

A little water leak repair on a Boxster.

Not strictly a FixItWorkshop blog article really, but hey!  It’s a cheap fix.

My beloved 2003 Boxster developed puddles in the umbrella holder on the passenger side (RHD car) when it rained hard.

The window was adjusted correctly and the door aligned properly, but when it rained, water ran down near the door mirror, under the seal, down the door card and in to the umbrella holder area.  Water leaks like this, especially on the passenger side (RHD car) are a real problem on the Boxster, since the cars’ ECU is mounted on the floor on that side and is big £££ to replace/ repair if it fails.

Seemingly, the door seal rubber on the car adjacent to the door mirror area had worn and become slightly porous and was allowing water to get in between the glass and seal.

New door seals are very expensive and to prove the issue, I applied a small trace of tap (faucet) silicone grease to the area to restore the wax-like finish, the seal should have to seal properly.

This has fixed the problem for now.  The door seal is worn and will need replacing in the long-term, but for now, this is a very cheap fix.

 

Kenwood Chef Repair

Kenwood repair in Worthing, West Sussex

Smelly Kenwood Chef A901

img_2959-resized-smaller
FixItWorkshop, Worthing, Jan’17.  Repaired Kenwood Chef A901

This Kenwood Chef developed a nasty little problem. The failure smelled expensive and the Chef even puffed out some smoke when it began to fail, it would operate, but noisily and badly, so it to the workshop it had to go.

It was in decent overall condition and has loads of accessories, so definitely worth saving since a new one is over £300 new.

Since the speed control circuitry is a common failure on models of this age, it seemed sensible to start there.  On this unit, access wasn’t a problem and the issue was quickly diagnosed.  Both capacitors had failed (spectacularly)  and one of the resistors had become weak by about 20 Ohms or so.  Repair kits are readily available online for those who are willing to save these excellent machines, so after removing the faulty components, new items were fitted.

Another little annoying problem with the Chef, was the main drive belt.  It was intermittently rubbing the main plastic body of the unit, making a horrible sound and melting some of the casing (only cosmetic).  The motor mounting spacer had compressed on one side causing the belt to not run correctly.  This was fixed with a small washer to correct the belt’s alignment.

With a little bit of grease, WD40, Brasso, contact cleaner, repair kit and washer, the whole job took a couple of hours (including fettling time) and cost me under £8.  Definitely worth the effort considering the price of a replacement Chef.

Here’s a picture of the new components fitted in situ…

img_2958-circles
FixItWorkshop, Worthing, Jan’17.  New capacitors, resistors and triac fitted, fixed!